409-35018
Rev A
15
of 15
5.
MAINTENANCE
The HDP-400 requires filtered, dry air. The tool is thoroughly lubricated at the factory and if clean, filtered, dry
air is provided, it should not require additional lubrication for the first year. The tool is assembled with the
highest quality O-ring lubrication, which should provide adequate lubrication under normal conditions for the
lifetime of the tool. If it becomes necessary to lubricate the tool, Dow Corning DC-55 O-Ring lubricant is
recommended.
6.
REPLACEMENT AND REPAIR
To obtain replacement parts, refer to the applicable instruction sheet or customer manual and order parts
through your TE representative. You can also order parts by any of the following methods:
Go to
Shop TE
link at the top of the page.
Call 800-522-6752.
Write to:
CUSTOMER SERVICE (038-035)
TE CONNECTIVITY CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair services, call 800-522-6752.
