TE Connectivity EPP-4024-7/22, Руководство по эксплуатации

Страница: 3 / 12

EPP-4024-7/22 • 3/12
1. Safety
1.1 Important Instructions
1.2 Product Compliance
FCC Compliance Statement
This device complies with Part 15 Subpart C of the FCC Rules. Operation is subject to
following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any
interference received, including that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of
20 cm between the radiator and human body.
DANGER
Welding is dangerous to the operator and people in or near the working area, if the equipment is not correctly
operated. Welding must be performed under the strict observance of all safety regulations.
WARNING
Only qualified operators should perform the welding procedure.
WARNING
Smoke and gas generated during welding operation is harmful to health.
Avoid breathing of smoke and gas generated during welding.
Wear appropriate protection equipment.
WARNING
Exothermic reaction during the welding may cause fire, remove the flammable materials away from the working
area.
CAUTION
As TE Connectivity (TE) has no control over field conditions, it is understood that the user must take this into
consideration and apply his own experience and expertise when operating the product.
CAUTION
Read and understand the contents of these instructions before operation and follow all locally approved
procedures and safety practices before installing or operating this equipment.
CAUTION
These instructions cannot cover all details or variations in the equipment, procedures, or processes described,
nor provide directions for meeting every possible contingency during installation, operation, or maintenance.
When additional information is desired to satisfy a problem not covered sufficiently for the user’s purpose, please
contact your TE sales representative. These instructions are not intended to supersede or replace existing safety
and operating procedures.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTICE
Upon receipt of the product, inspect it thoroughly for damage and loss of parts incurred during shipment. If
damage or loss is discovered, file a claim with the carrier immediately or contact your TE representative.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RoHS Compliance Statement
Based on the certificate of compliance provided by our suppliers, and to the best of our knowledge, TE Connectivity designates that
the parts used in the AMP Weld Controller are compliant with RoHS (Restriction of Hazardous Substance) directive 2011/65/EU
amended with directive 2015/863/EU as set forth by the European Union.
TE Connectivity does not intentionally add hazardous substances to the finished product. Our statements in this document regarding
RoHS compliance and lead content do not extend to, or apply to the product subjected to unintended contamination, misuse,
neglect, or accident.