408-1261
3
of 9
Rev K
4. Close the tool handles until the terminal is held
firmly in place. DO NOT deform the terminal.
5. Insert a properly stripped wire into the terminal
wire barrel until the end of the wire conductor(s)
butts against the locator.
DO NOT allow the wire insulation to enter the
terminal wire barrel.
Figure 3
6. Complete the crimp by closing the tool handles
until the ratchet releases.
7. Release the tool handles, allow the handles to
open FULLY, and remove the crimped terminal.
8. Inspect the crimp to make sure that it conforms to
Figures 7 and 8. Terminals not meeting the
described conditions should NOT be used.
B. Butt Splices
1. Open the crimping dies by closing the tool
handles until the ratchet releases, then allow the
handles to open FULLY.
2. Depress the locator. Position the splice in the
crimping chamber so that window indent of the
splice seats over the locator. See Figure 5.
3. Close the tool handles until the splice is held
firmly in place. DO NOT deform the splice.
4. Insert a properly stripped wire into the wire barrel
of the splice until the end of the wire conductor(s)
butts against the splice wire stop.
Figure 4
Figure 5
PRODUCT
WIRE STRIP
LENGTH
PIDG Vinyl and Nylon Terminal, PLASTI-GRIP
Terminal, and PIDG Radiation Resistant
Terminal
7.94-8.73
[.312-.344]
PIDG Insulation Restricting Nylon Terminal
9.65-10.4
[.380-.410]
PIDG Vinyl and Nylon Splice and PIDG
Radiation Resistant Splice
8.64-9.65
[.340-.380]
Spare Wire Cap
8.64-9.65
[.340-.380]
CAUTION
!
Содержание 59239-4
Страница 5: ...408 1261 5 of 9 Rev K Figure 7 ...
