409-35036
Rev A
8
of 15
DANGER
Do not handle pressurized hoses. Escaping oil under pressure can penetrate the skin, causing serious injury. If oil is injected
under the skin, see a doctor immediately.
DANGER
Use hydraulic cylinders only in a coupled system. Never use a cylinder with unconnected couplers. If the cylinder becomes
extremely overloaded, components can fail catastrophically causing severe injury.
CAUTION
Hydraulic equipment must only be serviced by a qualified hydraulic technician. For repair service, contact TE Connectivity (see
section 8,
). To protect your warranty, use only the hydraulic fluid specified in section 6.2
DANGER
Replace worn or damaged parts only with genuine original parts. Standard grade parts can break, causing injury and
equipment damage. Original parts are designed to fit properly and withstand high loads.
CAUTION
Carry the pump only by the pump frame. Lifting the pump by the hose can damage the hose or the pump.
DANGER
To avoid injury,
never
try to return more hydraulic fluid to the reservoir than it can hold. The pump has a non- vented reservoir.
High pressure in the reservoir can rupture the casing, causing injury and equipment damage.
DANGER
Make sure all hose connections are tightened, but not over-tightened. Connections must be secure and leak-free.
Overtightening can cause permanent thread failure, or cause high-pressure fittings to split at pressures lower than their rated
capacities. These failures can cause injury.
DANGER
System might be pressurized. To avoid injury, always release the pressure from the system before changing the crimping
head or die assembly or before disconnecting any connections from the pump.
DANGER
Never operate the pump without a hose assembly and crimping head attached to the pump. Doing so can cause injury.
2.2 Restriction on hazardous substances
For Information on the occurrence and location of all substances subject to the Restriction of Hazardous
Substances (RoHS) Directive, refer to the TE Connectivity
Product Environmental Compliance
Enter part numbers in the
Search by part # or keyword
field at the top of the page.
3 Receiving and inspection
The pump is inspected before shipment. When it arrives at your facility, inspect it immediately to ensure that it
was not damaged during shipping.
1. In a well-lighted area, carefully uncrate the pump and inspect each component as it is removed from
the crate.
2. Thoroughly inspect each component for evidence of damage that might have occurred in transit. If any
of the components are damaged, file a claim against the carrier and notify TE Connectivity
immediately.
3. Keep this manual and all drawings and product samples with the kit for the benefit of operation and
maintenance personnel.
