Tooling Kit
(Shown Installed)
Quick-Disconnect Ring
Air Cylinder
Foot Valve
Base
TERMINATOR
TOOLING KIT
(Included with
Terminator)
MODULAR
PLUG TYPE
354711-1
--
--
354711-2
354714-1
Line Plug
354711-3
354714-2
8 Positions
354711-4
354714-3
Handset
354711-5
354714-4
Long Body
354711-6
354714-5
10 Positions
354711-7
354714-6
6-Position Offset
354711-8
354714-7
High
Performance
(Category 5)
© 2013 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1
of 7
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.te.com
408-9919
Modular Plug Single Terminators
354711-[ ] and Tooling Kits 354714-[ ]
27 MAR 13 Rev G
Figure 1
1. INTRODUCTION
Modular Plug Single Terminators 354711-[ ] and
Tooling Kits 354714-[ ] are used to terminate modular
plug connectors. A specific tooling kit is included with
each modular plug single terminator. See Figure 1.
NOTE
Modular Plug Single Terminator 354711-1 does not
include a tooling kit.
Tooling kits consisting of a contact inserter, strain relief
stuffer, and a nest with a cover, may be purchased
separately to terminate other modular plug types and
sizes or to replace worn or damaged parts.
NOTE
All numerical values in this instruction sheet are in
metric units [with U.S. customary units in brackets].
Dimensions are in millimeters [and inches]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 12, REVISION SUMMARY.
2. DESCRIPTION
The terminator is a pneumatically powered, bench-
mounted tool controlled by a foot valve. This
terminator operates with a noise level of < 80 dBA. An
air cylinder is mounted vertically and operates a lever
that pulls the ram tooling down into the nest to
terminate the plug. Precise adjustments to crimp
height can be made by turning an adjusting screw for
the contact inserter. The contact inserter and strain
relief stuffer are held in the ram by a screw. The nest is
mounted on the front of the base, partially beneath the
ram, with one screw. Each terminator is designed to
terminate only one plug type. Refer to Figure 2 for the
pneumatic schmatic diagram.
NOTE
i
NOTE
i
O
R
IG
INAL
INST
RUCTIONS
