TDT System 3, Руководство по установке

Страница: 11 / 50

System 3 Installation Guide 11
Connect the WS optical interface to interface
dependent System 3 devices.
Processors and other interface-dependent devices mounted in a zBus chassis
(rack) must connect to the WS’s Optibit interface to form a communication
loop between the PC and the TDT hardware.
The WS’s Optibit interface port is located on the
back panel .
The RZ processor’s access to the Optibit interface is
located on the back panel .
The zBus chassis’ FO5 Optibit interface module is
mounted in a rear bay .
Use the provided fiber optic cables to make the connections described in the
step-by-step instructions below. Be sure to remove the clear plastic protective
plugs from the ends of the cables first.
Use the provided duplex fiber optic patch cables (orange) to connect the WS’s
factory installed, Optibit optical interface card to the processor(s). The fiber
optic ports on each device and the patch cables are color-coded and use key
and notch connectors to ensure correct wiring.