![TDK reylon plasma piezobrush PZ3 Скачать руководство пользователя страница 14](http://html1.mh-extra.com/html/tdk/reylon-plasma-piezobrush-pz3/reylon-plasma-piezobrush-pz3_operating-instructions-manual_3923901014.webp)
14
BA-PZ3_ML / F0354400
Attention
–
Damage to device!
Do not reach into the interior of the unit if no module is inserted and do not insert any
objects into the opening of the unit other than the modules provided for this purpose.
Hold the modules only in the front area as described above and avoid touching the
contact board and the piezo element.
Insert and remove the modules carefully.
7.2
Installation
•
Make sure that a module is inserted in the device.
•
Make sure that the air inlet and nozzle outlet are not covered so that a sufficient flow of
ambient air can be drawn in by the unit.
•
Hold the unit only in the area of the button (picture 4), not in the area in front of it
(picture 3).
•
If the unit is to be mounted stationary, please observe the instructions below regarding
electrically conductive objects (picture 5 to 8).
•
Ensure that the ventilation / extraction of the working area is sufficient.
•
Press the start/stop button to generate plasma
The device stops plasma activation after 5 minutes at the latest and goes into standby
mode (in the case of special modules, plasma activation can stop after a shorter period of
time).
You can return to the active mode by simply pressing the start/stop button and restart the
activation by pressing the start/stop button again.
Do not reach into the work area during plasma generation. This can disturb the plasma
discharge and can also cause skin irritation or be perceived as slightly painful.
3
4
(ES) Equipements Scientifiques SA - Département Composants & Modules - 127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 84 - Fax. 01 47 01 16 22 - e-mail: [email protected] - Site Web: www.es-france.com