TDK-Lambda HFE2500 Series, Инструкция по эксплуатации

Страница: 1 / 20

HFE2500 Series & HFE2500/S Series (Optional PMBus) Instruction Manual
HFE2500 SERIES SPECIFICATIONS: HFE2500-12/S HFE2500-24/S HFE2500-48/S
1 Rated output voltage V 12 24 48
2 Output voltage set point V 12+/-1% 24+/-1% 48+/-1%
3 Output voltage range V 9.6~13.2 19.2~29.0 38.4~58
4 Rated Output Current at 180 < Vin ≤ 265Vac (*1) A 200 104 52
5 Rated Output Current at 170 ≤ Vin ≤ 180Vac (*1) A 200 100 50
6 Rated Output Current at 100 ≤ Vin ≤ 132Vac (*1) A 125 62.5 31.25
7 Rated Output Current at 85V ≤Vin < 100Vac (*1) A Linear derating 1.3% per 1VAC from output current at 100VAC
8 Rated output power 180 < Vin ≤ 265Vac W 2400 2496 2496
9 Rated output power 170 ≤ Vin ≤ 180Vac W 2400
10 Rated output power 100 ≤ Vin ≤ 132Vac W 1500 1500 1500
11 Rated output power 85Vac ≤ Vin < 100Vac W Linear derating 1.3% per V
12 Input voltage / frequency range (*2) --- 85~265Vac continuous, 47~63Hz, Single phase
13 Maximum input current (*3) A 15/12A
14 Power Factor (Typ) (*3) --- >0.99/0.98 @ 115/230V and maximum output power
15 Efficiency at 75% rated load (Typ) (*3) % 90/92% 90/92% 91/93%
16 Efficiency at 100% rated load (Typ) (*3) % 89/91% 89/91% 90/92%
17 Inrush current (*4) A Less than 50A
18 Hold-up time (*13) mS
≥ 10mS typical at 115/230Vac input, rated output voltage and
less than 80% of rated load.
19 Maximum line regulation (*5) % 0.25%
20 Maximum load regulation (*6) % 0.50%
21 Output Ripple and noise P-P 0~+70°C (*7) mV 240 240 480
-10~0°C mV 360 360 780
22 Temperature stability %
0.05% of rated Vout for 8hrs after 30min warm-up. Constant
line,load and temperature.
23 Temperature coefficient PPM/°C +/-200
24 Remote sensing (*8) --- Possible. Refer to instruction manual.
25 Parallel operation (*9) ---
Possible. Single wire current share, 5% accuracy of rated Iout, up
to 8 units of the same voltage and the same current rating.
26 Series operation --- Possible (with external diodes), 2 units. Refer to instruction manual.
27 Over current protection 85 ≤ Vin ≤ 132Vac
% Minimum 110% of rated output current.
170 ≤ Vin ≤ 265Vac 105~120% of rated output current.
28 Over voltage protection (*10) V Tracking OVP, range: 1.1xVout, accuracy: +/-3%
29 Over temperature protection --- Inverter shut down method, automatic reset.
30 Remote On/Off control ---
Two complementary inputs. By electrical signal or dry contact.
Refer to instruction manual.
31 "DC OK" signal ---
Tracking, On when Vout>90+/-5% of set output voltage.
Open collector signal. Max.sink current: 10mA
Refer to Instruction Manual.
32 Over-Temperature warning ---
Refer to instruction manual. Open collector signal, Max. sink
current: 10mA.
33 "AC FAIL" signal ---
On when 270Vac>Vin>85Vac. Open collector signal, Max. sink
current: 10mA.
34 Auxiliary power supply output (*3)
(*11)
--- 11.2~12.5V, 0.5A. 240mVp-p ripple and noise.
35 Vout programming by external voltage --- By 0~5V, equal to Vout min ~ Vout max. Refer to Instruction Manual.
36 Vout programming by external resistor --- By 1Kohm potentiometer . Refer to Instruction Manual.
37 OCP programming by external voltage --- By 0~5V. Refer to Instruction Manual.
38 Front panel indicators --- AC OK, DC OK/FAIL. Refer to Instruction Manual.
39 I²C Interface --- Optional, PMBus compatible. Refer to Instruction Manual.
40 Operating temperatue (*14) ---
-10~70°C.
-10~50°C: 100% load. Derate 2%/°C, 50°C to 60°C, Derate
2.5%/°C, 60°C to 70°C.
41 Storage temperature --- -30~85°C
42 Operating humidity --- 10~90% RH, no condensation.
43 Storage humidity --- 10~95% RH, no condensation.
44 Cooling ---
By internal Fans. Variable speed control by ambient temperature
and power level.
45 Vibration --- Built to meet IEC60068-2-64 (Basic Transportation)
46 Shock --- Built to meet IEC60068-2-27 (Basic Transportation)
47 Conducted emission --- Built to meet EN55022 Class B, FCC part 15 Class-B, VCCI Class-B
48 Radiated emission --- Built to meet EN55022 Class A, FCC part 15 Class-A, VCCI Class-A
49 Immunity ---
Built to meet IEC61000-4-2 (Level 2,3),
-3 (Level 2), -4 (Level 2), -5 (Level 3,4), -6 (Level 2), -8 (Level 4), -11
50 Applicable safety standards --- UL60950-1, EN60950-1
51 Withstand voltage ---
Input-Output: 3000Vrms, 1min. Input-Ground: 2000Vrms, 1min.
Output - Ground: 500VAC 1min.
Output - Ground:
2250VDC 1min, (POE)
52 Insulation resistance --- More than 100Mohm at 25°C and 70% RH. Output-Ground: 500Vdc
53 Leakage current (*12) mA Less Than 0.75/1.5mA at 115/230Vac range
54 Weight (Typ) Kg Max 2.1
55 Size (W*H*D) --- 107x41x325mm Refer to Outline Drawing.
1