INSTALLATION GUIDE / CUT OUT TEMPLATE
Designed in Los Angeles, CA | 1 (866) TDG 6321 | www.TDGAUDIO.com
When using the Skybar speakers as a single speaker, connect to
Single Channel inputs only.
Ensure that the toggle switch is flipped toward Single Channel.
SINGLE CHANNEL
We highly recommend that you paint the grilles prior to installa�on.
If you decide to paint the grilles in the future, it is best to remove
the grilles by simply detaching them from the speaker. When
pain�ng the grilles, remove the clothe material behind the grille
and be careful not to clog the holes of the grille. Make sure the
paint is completely dry before rea�aching.
PAINTING
Skybar LCR can be used to play 3 separate channels, intended for
Le�, Center, and Right channels from an AV Receiver.
Skybar Satellite can be used to play 2 separate channels, intended
for Surround channels from an AV Receiver.
When moun�ng Skybar Satellite in the ceiling, point angled speaker
towards rear wall for a reflec�ve rear surround.
When moun�ng Skybar Satellite in the wall, point angled speaker
towards the ceiling for a reflec�ve height speaker.
Ensure that the toggle switch is flipped towards Mul� Channel.
MULTI CHANNEL
Prior to actual installa�on of the Skybar speakers, it is necessary to
run cable to the speaker loca�ons.
For new construc�on applica�ons, a new construc�on bracket may
be installed prior to drywall to allow precise placement and ease of
final installa�on. For exis�ng construc�on applica�ons, use this cut
out template. If you are not sure of poten�al obstruc�on behind
the moun�ng area, start by cu�ng a small hole at a 45 degree angle
towards the inside of the hole in the center of your penciled
moun�ng hole.
Cu�ng a small hole at an angle first will make drywall repair much
easier if necessary. See diagram below.
Once confirmed that there is no obstruc�on behind the moun�ng
area, finish cu�ng the hole at a 90 degree angle.
Connect the speaker cable to either terminals while ensuring proper
polarity with the amplifier, + to +, and - to -. Insert the speaker and
secure the speaker with wood screws on the front of the baffle.
A�ach the metal grille to the front of the speaker.
The Skybar LCR has an angled baffle to direct sound to the listening
area. Point the speakers towards desired listening area.
CAUTION:
Do not over�ghten the screws. This could damage the
speaker, wall, surface, or both.
INSTALLATION
Before installing the speakers, carefully plan the loca�ons of the
speakers accoun�ng for poten�al electrical, plumbing, and other
fixtures.
Keep speakers approximately 1 foot away from corners and other
surfaces that might interfere with or cause sound reflec�on.
Contact your local dealer if you need help installing the speakers.
GENERAL INFORMATION
