01/2013
13
TCS TürControlSysteme AG, TCS Hotline Deutschland: +49 (0) 41 94/ 9 88 11 88
Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129
Mail: [email protected]
PI_K30001-30004_uk 1A
Connection diagram K30001/K30003
Connection diagram K30002/K30004
2-wire special operation
!
It is not permitted to form a P-wire with a bridge between the terminals a and P!
Close the post
1.
Screw in the grub screw until it is flush with the surface and push the back panel
downwards until stop.
Fix the back panel with both knurled screws.
2.
Insert the upper back panel and push it downwards until it is flush with lower back
panel.
Fis the back panel with both knurled screws.
3.
Fix the roof of the post with the 4 screws.
It is absolutely necessary to insert the rubber rings again to prevent water from
entering the post here!
Commissioning
First install the system completely, than connect it to the mains voltage!
!
Please observe when using front-door stations with camera or dome camera module:
V1 and V2 must not be connected with P-, a- or b-wire.
When connecting the video wires V1 (+) and V2 (-) please observe the polarity.
Check the a-, b- and P-wire against each other for short circuits.
Switch ON the mains voltage.
K post
audio
K post
video
