07/2015
7
TCS TürControlSysteme AG
Subject to technical changes.
E-
Mail: [email protected] • www.tcsag.de
PI_ISW3130-uk 2 A
Connect the lines (2-wire technique)
Minimize the length of the lines above the
lower cover to place without any problems
and do not clamp when snapping-on the
upper cover.
Connect the lines according to the labeling:
a b E P (from the button to the top), floor
push button at a
– E.
Wiring example see page 9.
Snap-on the upper cover
Set on the upper cover at both adjustment
increments of the lower cover (
1
).
Snap-on the upper cover below with slight
pressure (
2
)
Open the device
There is a rectangular release opening at
the underside of the device. Insert a small
screwdriver right straight and with slight
pressure into this opening.
The upper cover can be removed at the
underside (
1
).
Lift the upper cover out of the two upper
adjustment increments (
2
).
1
2
1
2
floor push button
