DR
AF
T
7.3 Push Button Configuration Mode
Push Button Configuration provides a basic means of configuring the CS-105 using only the push button
and status LEDs on the device.
At any time,
Push Button Configuration Mode
can be entered by pressing and holding down the push
button for 10 seconds. Once all of the four status LEDs appear solid on, the CS-105 is in Push Button
Configuration Mode. In this mode you have
30 seconds
to select the configuration action you want to do by
pressing the push button briefly one to five times. If the button is not pressed again for 30 seconds, the
CS-105 will automatically exit Push Button Configuration Mode and return to normal operations without
making any changes. After you make a selection, all four leds will blink as many times as your selection,
then after three such confirmations, the selected action will be executed and the CS will reboot.
If you want to cancel Push Button Configuration Mode after having made a selection, press the button
again as many times as needed for a total of 6x presses. All four LEDs will then appear solid on. In this
state you can wait for the timeout to return to normal operation.
7.3.1 Secure AP Configuration Mode Entry
This action is selected by a
long press, then 1x short press.
The CS-105 will reboot and start up in WiFi Access Point Mode using WPA2 security with the currently
configured password (default is LAYOUTWIFI with password 123456789).
7.3.2 Open AP Configuration Mode Entry
This action is selected by a
long press, then 2x short presses.
The CS-105 will reboot and start up in WiFi Access Point Mode using no security.
Warning:
In this mode, the CS-105 is not secure. In this mode, it is relatively easy for anyone to
connect to the CS-105 with any WiFi device, intentionally or unintentionally. This mode is not
recommended for prolonged use. This mode is primarily designed to allow you to recover the
system and access the configurations for the WiFi in the event that you lose or forget your WiFi
Password.
7.3.3 WiFi Client Mode
This action is selected by a
long press, then 3x short presses.
The CS-105 will reboot and start up in WiFi Client Mode. In this mode the CS-105 will automatically connect
to a nearby WiFi network for which the network name (SSID) and password was stored in the settings. The
WiFi LED will be blinking during the search and connection process.
If the WiFi LED keeps blinking, that means that the CS-105 is in WiFi Client mode, but can not find any of
the configured WiFi networks nearby, or is unable to connect, for example because the password is
incorrect.
The factory default settings have one WiFi network saved, named LAYOUTWIFI with password 123456789.
7.3.4 WPS Configuration Mode Entry
This action is selected by a
long press, then 4x short presses.
© 2022 Train Control Systems
Page 30 of 49
