TCS AZC41000-0010, Информация о продукте

Страница: 9 / 28

9
Close the housing
► Connect the plug of the name plate illumination (see instal-
lation).
► Push the enclosed win:clip key into the small opening within
the loudspeaker cover.
► Press the key into the opening until stop and keep it in this
position.
► Push the name plate glass under the loudspeaker
cover.
► Press the name plate glass onto the device. Push it slightly
downwards until it snaps-in.
► Remove the win:clip key.
Fig. 3: win:clip
TM
, close
Install the front door station
► Open the device (see win:clip system)
► Perforate carefully the foam cover on the backside of the device.
ATTENTION! Damage to the connection wires.
Ensure that the cables from the rear panel do not get clamped.
► Mount the device via the mounting holes onto the wall using suitable screws.
Connecting the lines
Connecting lines
Allowed cross-section (diameter): 0,08 ... 1 mm
2
(Ø 0.3 ... 1.4 mm)
Max. number of wires per terminal contact: 2 x 0.8 mm or 3 x 0.6 mm
Connect further wires by using auxiliary terminals.
Use only connecting lines made of the same material and with the same diameter within one
terminal contact.
General information
• Use the small slot screwdriver (enclosed in the delivery) to connect the lines. Avoid damag-
ing the device.
• The internal resistance of the door opener shall not exceed 6 Ω .