TCRS AH150TON, Руководство по эксплуатации и обслуживанию

Страница: 4 / 13

Contact TCRS at 440-658-2020 3
Universal Warning
Do not operate or work on this equipment unless
you have read and understand the instructions
and warnings in the Operation and Maintenance
Manuals. Failure to follow the instructions or heed
the warnings could result in serious injury or
death.
Electrical Shock
The safety message for electrical shock is located on the control panel.
WARNING! Shock/Electrocution Hazard! Read
and understand the instructions and warnings in
the Operation and Maintenance Manual. Failure to
follow the instructions or heed the warnings
could cause serious injury or death.
Additional Messages
There are several warning labels on this unit. Please be aware of all warning labels.
Make sure that all of the messages are legible. Clean the messages or replace the messages if the words or images are
unreadable. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh
chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the
messages. Loose adhesive will allow the messages to fall off.
Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on
the replacement part.
General Hazard Information
Attach a “Do Not Operate” warning tag to the start switch or controls before the
unit is serviced or repaired. Attach the warning tags to the unit and to the operator
control station. When appropriate, disconnect the starting controls. Do not allow
unauthorized personnel on the unit, or around the unit when the unit is being
serviced. Cautiously remove the following parts. To help prevent spraying or
splashing of pressurized fluids, hold a rag over the part that is being removed.
• Gage ports
• Breathers
• Drain plugs
Use caution when cover plates are removed. Gradually loosen, but do not remove
the last two bolts or nuts that are located at opposite ends of the cover plate or the
device. Before removing the last two bolts or nuts, pry the cover loose in order to
relieve any spring pressure or other pressure.
Wear a hard hat, protective glasses, and other protective equipment, as required.
Do not wear loose clothing or jewelry that can snag on parts of the unit.
Ensure that all protective guards and all covers are secured in place on the unit.
Never put maintenance fluids into glass containers. Glass containers can break.
Use all cleaning solutions with care.
Report all necessary repairs.