The Setup menu
59
Output page
Output parameter
Stereo setting
When you set the Output parameter to Stereo, the left and
right audio channels are output to the left and right ¼” TRS
jacks when connected to a stereo monitor or PA system.
The XLR jack will output the left side audio only.
Mono setting (default)
The factory setting is that the left TRS output and the XLR
output contain the summed mono mix including effects. The
right TRS jack outputs your dry voice with Tone applied to the
mic input signal but no effects. Sending both a mono mix of the
effects and the dry signal to a mixing desk is useful when a live
sound engineer wants to control the balance of wet/dry mix
at the mix position. In this case, set the Lead Mute parameter
to On.
Dual Mono setting
When you set the Output parameter to Dual Mono, the left
TRS output and the XLR jacks output the effected vocal, and
the effected guitar signal is output from the right TRS jack. In this
configuration, a sound engineer can control the level balance
between the mono wet vocal (i.e. vocal with harmonies and
effects) and the mono wet guitar signal.
Vocal Cancel feature
The Vocal Cancel parameter engages signal processing on the
Aux input only that can reduce the vocal in a stereo music and
vocal recording.
Lead Mute parameter
When you have connected your microphone to an external
preamp that is feeding a PA, and VoiceLive Touch 2 is fed from
that PA mixer’s aux send, set the Lead Mute parameter to On.
This removes your dry voice from the mix. With Lead Mute on,
only the effects are heard on the outputs.
Headphone Limiter parameter
If you set the Headphone Limiter parameter to values less that
0 dB, a peak limiting processor is engaged on the headphone
output only that can prevent hearing damage from unexpected
loud peaks.
Содержание VoiceLive Touch 2
Страница 98: ...Getting Support 92 Getting Support ...