TC Electronic Hall of Fame mini Reverb, Инструкция по эксплуатации

Страница: 12 / 18

Inputs, outputs, controls
Hall of Fame Mini Reverb 10
Inputs, outputs, controls
4
5
1
6
3
2
1. Power input
The power input of this pedal is a standard
5.5 / 2.1 mm DC plug (centre = negative). To pow-
er up your pedal, connect a power supply to its
power input socket. Hall of Fame Mini Reverb
requires a 9V power supply providing 100 mA
or more (not supplied). To minimize hum, use a
power supply with isolated outputs.
2. Audio input
The audio input of this pedal is a standard ¼”
jack (mono/TS). Connect your guitar to the audio
input of your pedal using a regular ¼” mono ca-
ble. For other setups, see the “Setup examples”
section of this manual.
3. Audio output
The audio output of this pedal is a standard ¼”
jack (mono/TS). Connect the audio output of
your pedal to the next device in the signal chain
using a regular ¼” mono cable. For other setups,
see the “Setup examples” section of this manual.
4. Footswitch
Tap the footswitch to turn the pedal on or off, just
like with any other pedal on your board.
5. REVERB knob – Effect
level control
Use the Reverb knob to control the level of the
reverb. The amount of reverb that you can add
with this knob will vary depending on the Tone-
Print that you have loaded into Hall of Fame Mini.
! The direct, unprocessed signal is always
passed at the original level (unity gain). Only
the level of the reverb is changed when turning
the REVERB knob.
! Please note that you can control parameters
other than reverb level to the REVERB knob
by using TC’s TonePrint Editor. The parameter
assigned to the Reverb knob is stored as part
of the TonePrint.
6. USB port
Use this standard Mini-B USB port to connect
your pedal to a computer. This will allow you to
load new TonePrints into the pedal or create your
own using TC’s TonePrint Editor – it’s 100 % free
of charge! If there should be firmware updates
for this device, they can also be installed using
this port.