Update the SD card content
You can download the content manually from the
when you scroll down - make sure to
select the correct version depending on your FreedomTX version.
1. Power up your Tango 2 and connect it by
USB-C
2. In the prompt, select
USB Storage (SD)
3. Wait for your pc to mount the drive
4. Copy the complete content in to the SD card of
the Tango 2 and override the existing files
Update from FreedomTX 1.XX to 1.2X or later
Due the massive changes coming with FreedomTX 1.2X, the update process from a lower version differs
from the normal update routine:
●
Update FreedomTX
●
Now the update process stops at
Verification
and the T2 Display shows
Pls update Crossfire
●
When you leave the FreedomTX overview in the Agent X you’ll find the Micro Tx in Bootloader
mode - update the Crossfire to 4.00 or later
●
This will take only a few seconds and the radio will then boot up normal
●
Now update the Crossfire Micro Tx again - in the first time only the transmitter firmware was send
to the radio - now you also the receiver firmwares are transferred
●
Update your SD card content
Once you are on 1.2X or later, this is no longer necessary.
Firmware dependencies
Certain firmware versions require other devices to have a minimum version to work properly:
●
FreedomTX 1.1X -> Crossfire 3.XX
●
FreedomTX 1.2X -> Crossfire 4.00 (or later)
●
FreedomTX 1.25 -> Crossfire 4.10 (or later)
●
Freedomtx 1.29 -> Crossfire 4.11 (or later)
44
