tbs electronics Omnicharge OCD12/12-50, Руководство пользователя, Страница: 17 / 91

16
The LED error table below explains what error types are linked to what LED blinking
sequences:
Input LED Output LED Error type
Flashing red (1 blink) Input overvoltage
Flashing red (1 blink) Output overvoltage, Output undervoltage,
battery temperature too low or too high
Flashing red (2 blinks) Output overload / short circuit
Flashing red (3 blinks) Charger high temperature
4. TROUBLESHOOTING GUIDELINE
Please see the table below if you experience any problems with the Omnicharge DC battery
charger and/or the installation.
Problem Possible cause Remedy
Omnicharge DC is not
working at all. No input voltage Check wiring and input fuse
Input voltage is too low Check input voltage, adjust
the input voltage settings,
start engine
No positive signal on main
On/Off control wire Check wiring, fuses and
status of engine run signal
Positive signal on BMS input Check output battery BMS
status
Very poor input battery
condition Replace battery
The battery is not being
charged u
p to it’s maximum
capacity.
Incorrect absorption charge
voltage setting Check the battery type
selection for correct setting.
Or adjust the absorption
voltage
Incorrect charge current
setting Make sure that the
maximum output current
setting is at maximum level
(check if allowed by battery
manufacturer)
Too much voltage loss in
battery cables and/or
connections Make sure that the battery
cables have a large enough
diameter. Check if all DC
connections are solidly
made.