TRU-THERM
™
INSTALLATION & OWNERS MANUAL
9
Step 4- Install Remaining Panels
•
Install the door panels as shown below in Figure H.
•
The top panel may be installed now or may wait until step 10 (installer
preference). There should be 20mm clearance between the top panel and the
lintel.
•
Install side hinges onto left side of panel by screwing through pre-drilled holes in
end caps, install roller into vertical track, then rotate the panel into position and
stack. Then align panels and secure right hand hardware. (Screws will penetrate
reinforcing struts in panel- see Figure H on next page.)
FIGURE H
