16/ 42
Guide bar
Assembly
1. Before removing the guide bar, the following parts need to be removed.
·Water pump. (refer
to ZT1P52MI engine maintenance manual for disassembly and assembly - water pump)
·Tensioner.
(refer to ZT1P52MI engine maintenance manual for disassembly and assembly--cylinder head cover, cylinder
head-tensioner)
·Cylinder head cover parts.
(refer to ZT1P52MI engine maintenance manual for disassembly and assembly--cylinder head cover,
cylinder head-cylinder head cover)
·Cylinder head assembly.
(refer to ZT1P52MI engine maintenance manual for disassembly and assembly--cylinder head cover,
cylinder head-cylinder head)
2. Remove the guide bar.
Inspection
1. Check the guide bar for excessive wear or damage.
Install
1. As shown in the figure, install the guide bar. (note: after the guide bar is installed in place, the convex point of the guide bar is
lower than the joint surface of the cylinder block and cylinder head.)
align
Insert the guide bar into the limit card slot
