Taylor RD30, Руководство оператора

Страница: 17 / 38

Section 6
6-1
Models RD30/RC25
Operating Procedures
6
Operating Procedures
We begin our instructions at the point when the parts are
disassembled and laid out to air-dry from the previous
night’s cleaning.
The following procedures will explain how to assemble
the parts into the freezer, sanitize them, and prime the
freezer with fresh product.
If you are disassembling the machine for the first time or
need information to get to this starting point in our
instructions, go to “Disassembly” on page 6-9, and start
there.
Assembly
WARNING! Make sure the control switch is in
the OFF position to eliminate the chance of moving parts.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts.
Note: When lubricating parts, use an approved

food-grade lubricant (example: Taylor Lube HP). Every 3
months discard rubber parts and install new rubber parts.
1. Lubricate the O-ring groove. Slide the O-ring into the
first groove on the driveshaft. Lubricate the groove,
O-ring, and shaft portion that comes in contact with
the rear shell bearing on the beater driveshaft.
Do
not lubricate the square end of the driveshaft.
Figure 6-1
2. Slide the seal over the shaft until it snaps into the
groove. Fill the inside portion of the seal with
lubricant and evenly lubricate the flat side of the seal
that fits onto the rear shell bearing.
Figure 6-2
3. Install the driveshaft into the freezing cylinder, square
end first. The driveshaft seal must fit securely over
the rear shell bearing. Make sure the driveshaft fits
into the drive coupling without binding.
Figure 6-3
WARNING! Use extreme caution when
handling the beater assembly. The scraper blades are
very sharp and may cause injury.
Apply the appropriate
Taylor approved food safe lubricant.
HP
Apply the appropriate
Taylor approved food safe lubricant.
HP
Apply the appropriate
Taylor approved food safe lubricant.
HP