Section 6
6-1
Model C723
Operating Procedures
6
Operating Procedures
The Model C723 is a medium-capacity soft serve
machine. Mix is stored in the hoppers. The mix flows by
gravity through a feed tube into the freezing cylinders.
The machine is equipped with a three-spout door and two
2.8 qt. (2.7 L) freezing cylinders.
Note:
Some machines are equipped with a
factory-installed agitator option. For these machines,
please note the agitator instructions.
We begin our instructions at the point when we enter the
store in the morning and find the parts disassembled and
laid out to air-dry from the previous night's cleaning.
These opening procedures will show you how to
assemble the parts into the freezer, sanitize them, and
prime the freezer with fresh mix in preparation to serve
your first portion.
If you are disassembling the freezer for the first time, or
need information to get to this starting point in our
instructions, turn to page 6-9, “Disassembly,” and start
there.
Assembly
Note:
When lubricating parts, use an approved
food-grade lubricant (example: Taylor Lube).
WARNING!
Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Lubricate the groove on the beater driveshaft.
2. Slide the beater driveshaft boot seal over the small
end of the beater driveshaft and engage into the
groove on the shaft.
3. Heavily lubricate the inside portion of the boot seal.
Also lubricate the flat end of the boot seal that comes
in contact with the rear shell bearing.
4. Apply an even coat of lubricant to the shaft.
Do not
lubricate the hex end.
Figure 6-1
Note:
To ensure that mix does not leak out of the back
of the freezing cylinder, the middle section of the boot
seal should be convex, or extend out from the seal. If the
middle section of the boot seal is concave, or extending
into the middle of the seal, turn the seal inside out.
Figure 6-2
5. Insert the beater driveshaft through the rear shell
bearing in the freezing cylinder and engage the hex
end firmly into the drive coupling.
11470
Apply the appropriate
Taylor approved food safe lubricant.
11155
Содержание C723
