Taylor C302, Руководство оператора

Страница: 28 / 52

6-2
OPERATING PROCEDURES
Model C302
Operating Procedures
6
3. Slide the seal and bushing over the shaft and groove
until it snaps into place. Fill the inside portion of the
seal with more lubricant and evenly lubricate the end
of the seal that fits onto the rear shell bearing.
Figure 6-3
4. Insert the beater drive shaft into the freezing cylinder,
hex end first, and into the rear shell bearing until the
seal fits securely over the rear shell bearing. Make
sure the drive shaft fits into the drive coupling without
binding.
Important! Remove any excess lubricant from the
seal.
Figure 6-4
5. Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear. If any
nicks are present or if the blade is worn, replace both
blades. If the blades are in good condition, place the
scraper blades over the holding pins on the beater.
Note: Each hole on the scraper blade must fit
securely over each pin.
Figure 6-5
6. Align the flats on the end of the beater assembly with
the drive shaft. Make sure the beater assembly
locating pin is in position in the locating hole of the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will be approximately 3/8 in. (9.52 mm) inside
the front of the freezing cylinder.
Important! Failure to properly seat the beater may
cause damage to the beater and the door.
Figure 6-6
11509
11507
11112
10189