Taylor C300 NP, Руководство оператора

Страница: 5 / 52

Section 1
1-1
Model C300
To the Installer
1
To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.
Installer Safety
IMPORTANT! In all areas of the world,
equipment should be installed in accordance with
existing local codes. Please contact your local authorities
if you have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service
of Taylor
®
equipment.
• Only authorized Taylor service personnel should
perform installation, maintenance, and repairs
on Taylor equipment.
• Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the industry
standards on lockout/tagout procedures before
beginning any installation or repairs.
• Authorized service personnel must ensure that
the proper protective equipment (PPE) is
available and worn when required during
installation and service.
• Authorized service personnel must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
DANGER! The main power supply(s) to the
unit must be disconnected prior to performing any
installation, maintenance, or repairs. Failure to follow this
instruction may result in personal injury or death from
electrical shock or hazardous moving parts as well as
poor performance or damage to the unit.
Note: All repairs must be performed by an authorized
Taylor service technician.
WARNING! This unit has many sharp edges
that can cause severe injuries.
Site Preparation
Review the area where the unit will be installed. Make
sure that all possible hazards to the user and unit have
been addressed.
WARNING ! Only install this machine in a
location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.
For Indoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of

70
°F to
75
°
F (21
°C to
24
°
C). The u n i t has successfully
performed in high ambient temperatures of up to 104
°F
(40
°
C) at reduced capacities.
WARNING! This machine must NOT be
installed in an area where a water jet or hose can be
used. NEVER use a water jet or hose to rinse or clean
the machine. Failure to follow this instruction may result
in electrocution.
WARNING! Asphyxiation Hazard!

If used with CO2 (Carbon Dioxide) or N2 (Nitrogen),
always make sure the area is well ventilated.

Vent exhaust gas to outside atmosphere using a hose.

Failure to do so can cause serious injury.
!
!