Taylor-Dunn G0-010-00, Инструкция по обслуживанию и замене запасных частей

Страница: 48 / 362

2.24
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
FINAL DRIVE / WHEEL / TIRE
WHEEL AND HUB TORQUE TABLE
ITEM SPECIFICATION
Wheels Nuts
Torque: Steel Wheels:
36 ft-lbs (49 Nm)
Aluminum Wheels:
30 ft-lbs + 90º (41 Nm +
90º)
Front Hub Nut
90 ft-lbs (122 Nm)
Rear Hub Nut
110 ft-lbs (150 Nm)
CV SHAFT BOOT INSPECTION
Inspect the CV shaft boots in the front and rear for
damage, tears, wear, or leaking grease. If the rubber
boot exhibits any of these symptoms, replace the boot.
Refer to Final Drive for CV boot replacement.
WHEEL REMOVAL
RE-
F. DESCRIP-
TION NOTES
q Wheel Nuts Torque: Steel Wheels:
36 ft-lbs (49 Nm)
Aluminum Wheels:
30 ft-lbs + 90º (41 Nm + 90º)
w
Washers
1. Stop the engine, place the transmission in gear and
chock wheels.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable
stand under the footrest frame.
4. Remove the wheel nuts and washers and remove
the wheel.
WHEEL INSTALLATION
1. With the transmission in gear and wheels chocked,
place the wheel in the correct position on the wheel
hub. Be sure the valve stem is toward the outside
and rotation arrows on the tire point toward forward
rotation.
2. Attach the washers (if applicable) and wheel nuts
and finger tighten them.
3. Lower the vehicle to the ground.
4. Tighten wheel nuts to specification. Steel: 27 ft-lbs
(37 Nm)
Aluminum: 30 ft-lbs (41 Nm) + 1/4 Turn
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered wheel
nuts, make sure the tapered end of the nut goes into
the taper on wheel.
TIRE INSPECTION
• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original equipment
size and type.
• The use of non-standard size or type tires may affect
vehicle handling.
Tire Tread Depth
Always replace tires when tread depth is worn to 1/8" (3
mm) or less.
MAINTENANCE