Taylor-Dunn ET 3000, Руководство пользователя

Страница: 64 / 216

Steering
Page 12
MB-T48-02
T-48 AC / ET 3000
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. If equipped with a hand operated park brake, set the brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
REPLACE THE STEERING WHEEL
6. If equipped with a horn switch in the steering wheel,
remove the switch and disconnect the wires from
the switch.
7. Remove the steering wheel nut.
8. Using a steering wheel puller, remove the steering
wheel.
9. Position the front wheels in the straight ahead
position.
10. Lightly grease the steering wheel splines and install
the replacement steering wheel orientated as shown
in the illustration to the right.
11. Tighten the steering wheel nut to the specified
amount listed in the Hardware Torque Table at the
end of this section.
12. Reinstall the horn switch (if equipped).
13. Reconnect the main positive and negative cables
at the batteries.
14. Remove the blocks from behind the wheels.
15. Release the parking brake and test drive the vehicle.