Taylor-Dunn ET 3000, Руководство пользователя

Страница: 135 / 216

Battery
Page 7
MB-T48-02
T-48 AC / ET 3000
Individual Batteries
5. Using an insulated wrench, disconnect the cables
from the battery to be removed.
6. Using a lifting strap or hoist, remove the battery
from the vehicle.
7. Inspect the battery compartment for corrosion. If
there is significant corrosion, all batteries should
be removed and the compartment cleaned and
painted.
8. Install the battery and torque the battery terminal
hadware per torque listed in the Hardware Torque
table at the end of this section.
Do not allow the loose battery cables to contact
any other parts of the vehicle as this could cause
in a short circuit resulting severe bodily injury
or damage to the vehicle.
Individual batteries can weight up to 80 pounds.
To avoide injury, use proper lifting tecniques or
a hoist to remove the battery.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the battery connector from the
vehicle.
Roll Out Battery Box (ROBB) with battery Dolly
Remove
6. Disconnect the battery cable from the ROBB.
7. Position the ROBB dolly as close as possible to the
vehicle, aligned with the battery box.
8. Using the ROBB handle, twist to unlock the box from
the frame and pull the box out 6 inches.
9. Pump foot pedal 1 to raise the dolly tray until it is in
contact with the bottom the ROBB.
10. While pushing the dolly up against the vehicle, pull
the ROBB out of the vehicle and onto the dolly tray.
11. Tie the ROBB to the tray so that it cannot roll off.
12. SLOWLY depress foot pedal 2 until the tray starts to
lower and allow to lower all of the way down.
Install
1. Confirm the start switch is OFF and the parking brake
is set.
2. The ROBB should be tied to the dolly tray so that it
can not roll off.
3. Position the ROBB dolly as close as possible to the
vehicle, aligned with the battery box.
4. Pump foot pedal 1 to raise the dolly tray until it is
slightly above its location in the vehicle.
5. Untie the ROBB from the dolly and push forward until
it starts to enter the vehicle.
6. Using the foot pedal 1 and/or foot pedal 2, adjust the
vertical position of the dolly tray until the ROBB can
be easily pushed into the vehicle.
7. Lock the ROBB in place.
8. Connect the battery cable.
HARDWARE TORQUE
If hardware is not listed here, refer to standard torque
values in the appendix.
Description Inch Pounds Newton Meters
Battery Terminal (clamp) 48-60 5.4-6.7
Battery Terminal (stud) 120-130 13.5-14.5