Taylor-Dunn ET 3000, Руководство пользователя

Страница: 133 / 216

Battery
Page 5
MB-T48-02
T-48 AC / ET 3000
STORING
Storage
Thoroughly clean the battery and battery compartment.
Refer to
Cleaning
in this section for information
regarding cleaning the battery.
Check the electrolyte level and charge the battery. Refer
to
Watering
in this section for information regarding
checking the electrolyte level.
Store the vehicle or battery (if removed) in a cool, dry,
well ventilated area.
If storing for more than one month, the battery should be
charged per the table below.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and negative
battery leads.
CHARGING
Refer to the Operator Section for charging information.
•
Explosive mixtures of Hydrogen gas are
present within battery cells at all times. Do
not work with or charge battery in an area
where open flames (including gas furnace
or water heater pilots), sparks, cigarettes,
or any other sources of combustion are
present. Always provide ample ventilation
in rooms where batteries are being charged.
Failure to do so may result in severe bodily
injury and/or property damage.
•
A battery is a live electrical source. It
cannot be disconnected or neutralized. Do
not drop any tool or conductive object onto
the battery. A conductive object that comes
in contact with the battery terminals will
initiate a short circuit of the battery. This
could cause the battery to explode resulting
in severe bodily injury and/or property
damage.
•
Battery electrolyte is poisonous and
dangerous. It contains sulfuric acid. Avoid
contact with skin eyes or clothing. Wear
rubber gloves and safety glasses while
servicing batteries. DO NOT INGEST! This
may result in severe bodily injury.
Storage
Temperature
(F)
Charging
Interval
(months)
Over 60 1
Between 40
and 60
2
Below 40 6
Returning to Service
6. Thoroughly clean the battery and battery
compartment. Refer to
Cleaning
in this section for
information regarding cleaning the battery.
7. Check the electrolyte level and charge the battery.
Refer to
Watering
in this section for information
regarding checking the electrolyte level.
8. Test the battery. Refer to
Testing
section for
information on testing the battery.
9. The battery is now ready to be put back into service.