Taylor-Dunn C0-425-48, Инструкция по обслуживанию и замене запасных частей, Страница: 52 / 128

Drive Axle-GT
Page 52
C0-425-48
MC-425-13
PRIMARY GEAR CASE
1: Disconnect the batteries.
2: Raise the rear of the vehicle and support with jack
stands.
3: Place a drain pan under the gear case that is
capable of holding 4 liters (4 quarts) of oil and drain the oil from the front
gear case.
4: If required, remove the drive assembly from the vehicle. Refer to Remove
assembly procedure.
5: Remove the motor only if the entire drive is to be disassembled. Refer to
Motor procedure.
6: Remove the cover retaining bolts.
7: Remove the cover plate and let the remaining oil drain from the housing.
8: Remove the circlip from the idler gear.
9: Remove the input shaft/bearing assembly and idler gear/bearing assembly
from the gear case cover at the same time.
10: Remove the pinion nut from the output gear and remove the output gear
from the pinion shaft.
Note: If necessary, remove the seal from the input shaft bore at this time.
11: Mark the gear case position in relation to the 3rd member housing so that it
will be reassembled in the same position.
12: Remove the six retaining bolts holding the gear case to the 3rd member
housing.
13: Remove the gear case housing from the 3rd member housing.
14: Inspect all parts for signs of wear or damage.
15: Assemble the gear case in reverse order.
a. See note regarding special washers at the end of this section.
b. Apply gasket sealer (#94-430-05) to the front flange on the 3rd member and gear case cover.
c. Pack the motor seal with non-acetic based grease.
d. Torque the drain plug, gear case to 3rd member bolts, and pinion nut per torque listed in the Hardware Torque
table at the end of this section.
16: Fill the differential with oil. Refer to Check Oil Level for information on filling the drive with oil.
17: Lower the vehicle.
18: Reconnect the batteries.
19: Remove the blocks from behind the wheels.
20: Test drive the vehicle.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
Idler Gear Circlip
Remove Idler & Input Assy.