Taylor-Dunn BT-280 Series, Руководство оператора

Страница: 23 / 56

Page 23
Operator Manual
MB-280-02
Fault Codes
Note: Most faults are a result of a fault in the control system that will require service by a qualified
technician. These faults are shown here for reference only.
Operator correctable faults are shown in bold and underlined.
Level 1 Faults
Code Description What to do
F01000 P/S Motor Overheated Stop the vehicle and allow the system to cool down.
F01001 Motor Brush Fault Refer to service technician
F01002 Pump Motor Brush Fault Refer to service technician
F01003 P/S motor Brush Fault Refer to service technician
F01004 Low Battery Volts Batteries are empty and require charging. If this fault does not reset
after the charge cycle is complete then there may be a problem with
the charger or batteries. Refer to qualified service technician.
F01005 Controller Overheated Stop the vehicle and allow the system to cool. This could be a result of
an overloaded vehicle.
F01006 Traction Motor Hot Stop the vehicle and allow the system to cool down. This could be a
result of an overloaded vehicle
F01007 Pump Motor Overheated Stop the vehicle and allow the system to cool down.
F01008 Wiring fault Refer to service technician
Level 2 Faults
Code Description What to do
F02000 Throttle Fault Refer to service technician.
F02001 Throttle Fault Refer to service technician.
F02002 Belly Switch Fault Refer to service technician
F02003 Open Field Refer to service technician
F02004 Open Field L Refer to service technician
F02005 Open Field R Refer to service technician
Level 4 Faults
Code Description What to do
F04000 Open Contactor Refer to service technician
F04001 Contactor Welded Refer to service technician
F04002 Steer POT Fault N/A
F04003 Sequence Fault Start up switches were not operated in the correct order. Refer to
Vehicle Operation Guidelines for correct sequence.
F04004 F&R Fault Refer to service technician
F04005 F&R Fault Direction was selected before start switch was closed. Place direction
selector in the OFF position and restart.
F04006 Interlock Fault Seat or foot interlock switch not closed.
F04007 Inch Switch Fault Direction Control switch NOT in neutral.
F04008 Steer Fault Refer to service technician
F04009 Low Battery Volts Extreme low battery voltage at the controller. May be a result of
severely discharged battery or wrong battery installed. Confirm
that the correct battery is installed and charge the battery.
F04010 High battery Volts Refer to service technician
F04011 Out of Range Fault Refer to service technician
F04012 CRC Fault Refer to service technician
F04013 Capacitor Fault Refer to service technician
Level 5 Faults
All Level 5 faults indicate a failure in the motor speed control system. Refer repair to a service technician.