Taylor-Dunn BIGFOOT B5-440-36, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 80 / 130

Batteries
Page 80
B5-440-36 / B5-440-48
MB-440-01
TESTING
Specific Gravity
Note: The battery must be fully charged before
performing this test.
The specific gravity of a cell is an indication of the actual
state of charge of the cell. A fully charged cell should have
a reading of 1275 to 1300 (see the illustration below). A
discharged cell will read 1100. Ideally, all cells in a battery
will have the same reading. Any cells in a battery that
vary by more than 25 points may be an indication of a
bad or weak cell.
Clean the battery. Refer to Cleaning section for
information on cleaning the battery.
Using part number 77-200-00 hydrometer or equivalent
graduated type hydrometer, test and record the specific
gravity of each cell in the battery.
Use the highest reading to compare to all other cells. A
cell with a reading above (highest reading – 25 points)
should be suspected as being a bad cell.
If, after charging, none of the cells exceed a hydrometer
reading of 1250 then there may be a fault in the charging
system. If the charging system checks OK then the
battery pack is no longer accepting a charge and should
be replaced.
It may be possible to replace Individual cells in industrial
batteries. Contact the battery manufacturer for details.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter and beginning of this
section..
WARNING
DO NOT attempt to test the specific gravity of a sealed
battery. Removing the caps of a sealed battery will
damage the battery resulting in premature failure.
NOTICE
Typical
Hydrometer
Float
STORING
Storage
Thoroughly clean the battery and battery compartment.
Refer to Cleaning in this section for information
regarding cleaning the battery.
Check the electrolyte level and charge the battery.
Refer to Watering in this section for information
regarding checking the electrolyte level.
Store the vehicle or battery (if removed) in a cool, dry,
well ventilated area.
If storing for more than one month, the battery should
be charged per the table below.
Returning to Service
Thoroughly clean the battery and battery compartment.
Refer to Cleaning in this chapter for information
regarding cleaning the battery.
Check the electrolyte level and charge the battery.
Refer to Watering in this chapter for information
regarding checking the electrolyte level.
Test the battery. Refer to Testing section for information
on testing the battery.
The battery is now ready to be put back into service.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter and beginning of this
section..
WARNING
Storage
Temperature (F)
Charging
Interval
(months)
Over 60 1
Between 40 and 60 2
Below 40 6