Taylor-Dunn AMB Ambulance, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 107 / 266

Chargers
Page 3
Delta-Q
The Delta-Q charger has 10 pre-programed algorithms available.
Identify Active Profile
1: Disconnect AC power source and wait for LED’s to turn off.
2: Remove the positive charger lead from the battery.
3: Reconnect to AC power source.
4: After the self test completes, the current algorithm code will be displayed on the charger LED’s (see
illustration).
Codes 1 through 6 will show on the top LED’s and also flash the lower LED.
Codes above 6 will flash the lower LED.
Codes with 2-digits will flash the lower LED in sequence. Each digit will be followed by a short pause. There
will be a long pause after the code is complete and then it will repeat.
The algorithm code will be displayed for 11 seconds.
The following is the list of algorithms available in Taylor-Dunn chargers. Contact Delta-Q for any additional detail or
for information on codes not listed.
Code Mfg Battery Type Algorithm
1 Trojan Generic FLA
7 Trojan T145 FLA dV/dT
11 Generic 200-255Ah FLA dV/dT
26 Deka 8GGC2 GEL
42 Discover 80-150Ah AGM
43 Discover Generic AGM
51 Exide/Sonnenschein 180Ah GEL
71 Generic 140-200Ah FLA dV/dT
125 Full River 160-220Ah AGM
151 Full River 220-290Ah AGM
The algorithms stored in the Delta-Q charger will vary depending on
where the charger was obtained. The following information applies ONLY
to chargers purchased from Taylor-Dunn.
Using the incorrect charging algorithm may result in loss of run time due
to insufficiently charged batteries or premature failure of the batteries
due to overcharging.
NOTICE
PROGRAMMING