DIFFUSE ILLUMINATED MIRROR
Product code: SLE520
Installation & care instructions
Please retain for future reference
Tavistock, Brassmill Lane Trading Estate, Bath, BA1 3JF
T. 01225 787870 | F. 01225 448877 | E. [email protected] | W. www.tavistock-bathrooms.co.uk
ILLUMINATED MIRROR
SLE520
Before you start
1
2
It is recommended that the mirror is secured to a suitably reinforced wall to ensure stability. Wall plugs are only suitable for solid stone/ brick walls. For plasterboard walls use
specialist wall plugs (not supplied).
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is recommended. Beware of hidden pipes or
cabels. Take care when drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent the drill from wandering.
Strip wires to a suitable
length. DO NOT connect
to a plug & socket outlet.
THIS PRODUCT IS MANUFACTURED TO CLASS I
CATEGORY AND MUST HAVE AN EARTH CONNECTION.
! IF IN DOUBT CONSULT YOUR ELECTRICIAN !
Colour Coding:
L - Live
= Brown
N - Neutral
= Blue
- Earth
= Green & Yellow
Operating Instructions
Lighting is turned on / off using the infra red switch on the bottom edge of the mirror. To operate, wave your hand
underneath the sensor. The heated pad is on when the light is on. DO NOT leave on for prolonged periods of time.
Ref: MB.05.13 | V.1.00
Mount the Mirror onto the fixing bracket fitted to the wall. The fixing bracket will inside the frame of the mirror.
This mirror can be installed in a portrait or landscape orientation. To ensure the mirror is securely mounted, add a
bead of silicone to the bottom edge where the mirror meets the wall.
Installation Procedure
Before installation. Decide on a desired location for your mirror. This
mirror can be mounted in a portrait or landscape orientation. If mounting
Landscape the mirror must be mounted a minimum of 150mm from an
adjacent wall or obstruction to ensure correct function of IR sensor.
1) Mount the mirror fixing bracket to the wall using the fixing kit supplied.
Supplied wall plugs are only suitable for solid stone/ brick walls. For
plasterboard walls use specialist wall plugs (not supplied). The holes for
the fixing bracket should be 50mm below the desired height of the top
of the mirror. Ensure this plate is level using a spirit level before
mounting your mirror
.
2) The next step is to make the electrical connection from the mirror to
the mains supply. Use the connection wire found at the rear of the
mirror to make the necessary connections in accordance with the
current IEE regulations. A second person will need to hold the mirror in
place whilst electrical connections are made.
Important
Mirror Location
150mm
Minimum
distance
Infrared sensor
