27
Attention
Danger
3.4.4 Adjust the counter balance
3.2
3.3
Tauro 120
3.2
3.3
Taurox
300-900
Fig.: 3.14
The retraction force of the drive spindle can be set by the adjustment wheel (3.3).
Pull down the drive spindle by the operating lever (3.2).
If you release the operating lever (3.2) the drive spindle should be brought back in the end
position by its own because of the balance system. Take care that the retraction force is not
set to high!
Attention!
A too powerful retraction force reduces the lifetime of the thread tool and can
affect the quality of the working process.
By turning the adjustment wheel to the right side the retraction force of the drive unit
becomes stronger.
3.4.5 Adjust the workpart and height adjustment
30°
30°
4.3
4.4
3
Fig.: 3.15
•
Open the clamping lever (4.3).
•
Position the distance between spindle and workpiece higher than 10mm with the
hand crank (4.4).
•
It is possible to swivel the drive unit (3) around 30° to the left and to the right at a
time.
•
Clamp the clamping lever (4.2).
•
Secure the workpiece against torsional stiffness and unwanted moving.
Use only suitable clamping devices.
Danger:
Workpieces can turn with the tool and threaten peoples and
machines.