Tatuus GB3 CHAMPIONSHIP, Техническое руководство

Страница: 33 / 80

Version 1.03 34
switch is in the ON position before using the vehicle.
Every 2 years:
Have OMP or an OMP licensee perform the compulsory overhaul on the bottle. The date for the first overhaul
is shown on the extinguisher label.
Clean the system as follows:
2
Disassemble the nozzles from their connectors and the connectors from the hose.
3
Blow compressed air through the hose and into the connectors and nozzles. Blow the nozzles from
the sprayer side toward the connector.
4
Visually check that there is no rust on any of the system components. Replace all rusted
components.
5
Visually check the plastic and rubber on the connectors for wear. Replace any worn components.
6
Reassemble the system following the instructions provided in section 5.
2.12.7
Special situation
In the event the vehicle is flooded:
Disassemble, dry, and clean the system as follows:
1
Disassemble the nozzles from their connectors and the connectors from the hose.
2
Blow compressed air through the hose and into the connectors and nozzles. Blow the nozzles from
the sprayer side toward the connector.
3
Leave the system to dry completely and repeat the cleaning with compressed air.
4
Visually check that there is no rust on any of the system components. Replace all rusted
components.
5
Visually check the plastic and rubber on the connectors for wear. Replace any worn components.
6
Reassemble the system following the instructions provided in section 5.
7
disassemble the control unit, open the battery compartment, clean it, and leave it to dry. Replace the
9V battery that powers the system's electrical control.
8
conduct all the checks described in the "before every race" section, except for replacing the battery.
After an accident not involving fire in which the system is not activated:
•
check that all the fastening screws in the system are tight, especially those securing the bottle. If any
of the screws have come unfastened, replace them with new ones.
•
check that the bottle fasteners have not been warped in any way. If there are any deformations replace
the fastening brackets.
•
visually check the integrity of the hoses and orientation of the nozzles. Replace any damaged
components.
•
perform all the checks described in the "before every race" section.
After activation of the system when no fire was present:
•
have the bottle recharged by OMP or an OMP licensee.
•
clean the system as described in the section "in the event the vehicle is flooded".
•
perform all checks required in the event of an accident not involving fire and in which the system is
not activated.
After activation of the system when fire was present:
•
have the bottle recharged by OMP or an OMP licensee
•
replace the protective sheathes on the hoses.
•
clean the system as described in the section "in the event the vehicle is flooded".
•
perform all checks required in the event of an accident not involving fire and in which the system is
not activated.
2.12.8
Warranty
OMP extinguishing systems are guaranteed for a period of 24 months from the date of purchase in accordance
with EC Directive 99/ 44.
In countries outside the European Union, the warranty period may be different: in this case the period dictated
by the law in the country in which the extinguishing system was purchased will apply.
The warranty allows you to request replacement or repair of the extinguishing system free of charge from the
dealer from which you purchased the product if during the warranty period manufacturing defects arise that
are not attributable to use outside that described in this instruction manual.