TATA Motors Safari 2021, Руководство пользователя, Страница: 253 / 308

Special Care for Tubeless Tyres
While removing tyre from wheel rim •
and mounting it back on wheel rim,
take precautions not to damage tyre
bead. Use tyre removal and assembly
machines. Damage or cut on tyre bead
may cause gradual loss of air and de-
flation of tyre.
Do not scratch inside of tubeless tyre •
with metallic or sharp object. Tubeless
tyres are coated with impermeable
layer of rubber from inside which holds
the air inside the tyre. Removal of this
layer due to scratching may cause
gradual loss of air and deflation.
If wheel rim gets damaged in service, •
get the wheel rim repaired/ replaced
immediately. Running the vehicle with
damaged rim may cause deflation of
tyre and subsequent dislodging of tyre
from rim.
Maintain recommended inflation pres- •
sure. Over-inflation, in particular, may
cause puncture or bursting of tyre.
REMOTE KEY BATTERY REPLACE-
MENT (for Flip key)
Remote control key contains a battery,
which is housed under the cover.
If red LED on remote flashes for 5 times
after operating any button on remote. It is
recommended to replace battery at a TATA
MOTORS Authorized Service Centre.
You should, however, proceed as follows
if you wish to replace the discharged bat-
tery yourself:
Open the key blade. 1.
Press off the battery cover with your 2.
thumb or using a flat screwdriver at the
points of the arrows.
Remove the discharged battery from 3.
the key by pressing the battery down-
wards at the point of the arrow.
NOTE
Life and wear pattern of tyres de- •
pends on various parameters like
tyre pressure, wheel alignment,
wheel balancing, tyre rotation, etc. It
also largely depends on vehicle
speed, load carried, usage, driving
habits, road conditions, tyre quality,
etc. In case fault is suspected to be
due to poor quality of tyres, the
same may be taken up with con-
cerned tyre manufacturer.
For steel rim, Red dot of tyre to be •
matched with blue dot of rim while
re-fitment.
For alloy rim, Yellow dot of tyre to be •
matched with valve of rim while re-
fitment
MAINTENANCE AND SERVICES
245