34
Warning devices
Sensors
Relocation drive
Manual mode:
The direction of travel is controlled by the driving handles and
the speed with the driving switches. The speed is continuously
regulated.
When the driving switch is released, the machine is deceler
-
ated until it stops and the parking brake is activated.
Automatic mode
When the cleaning program is started, the machine is set into
motion. The direction of travel and speed are automatically
controlled.
Moving the machine (in the case of a malfunction)
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Squeegee assembly
Filling the fresh water tank
Fill fresh water tank with Aquastop-System
Attention:
Warning devices such as warning light,
flashing light and signal tone when revers
-
ing must be regularly checked for function
-
ing. Malfunctions must be eliminated
immediately. The operation of the machine
with missing or defective warning devices
requires increased caution and attention.
Caution:
National regulations always take priority.
These can require other behaviors and
must be adhered to.
Attention:
The ground sensors and the obstacle rec
-
ognition sensors must be checked to en
-
sure proper function and cleanliness prior
to each time of using!
Caution:
The ground sensors may not be covered!
Notice:
The suction nozzle / squeegee is automat
-
ically lifted and the cleaning solution sup
-
ply is interrupted for reversing during
operating mode.
Notice:
Generally, the machine should only be
moved by two people.
Attention:
Due to the high weight, manual movement
of the machine is risky!
Missteps can lead to personal injury and
damage to the machine.
• Moving the machine is only possible when the emergency
stop button is permanently engaged. (See page 31)
Notice:
When the front door is opened, the power
supply to the brush unit is capped.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
Notice:
The suction nozzle / squeegee must be
correctly inserted and secured.
The suction nozzle / squeegee can other
-
wise become detached from the holder
and cause damage to the machine and
ground.
Attention:
The front door must be closed so as to pre
-
vent splashing water from getting to the
electronics of the brush units.
Attention:
Max. permissible water temperature 60°C/
140°F.
Diversey recommends using cold water as
hot water will adjust to the ground tem
-
perature as soon as it is in contact with the
ground. Thus there are no advantages to
using hot water.
Notice:
The fresh water tank can be filled using a
water hose. The maximum filling level indi
-
cator is located on the outside of the ma
-
chine.
Notice:
This machine is equipped with a filling sys
-
tem.
Connect the water hose from the tap with
the Aquastop-System.
The Aquastop-System automatically stops
the supply of water when the maximum fill
-
ing level has been reached.
