12
Empty and clean the recovery tank and fresh water tank
Cleaning the recovery tank and fresh water tank
Cleaning the fresh water tank filter
Clean the fresh water tank filter after the end of operation.
Clogged filters can inhibit the supply of detergents and thus
lead to surface damage.
Removing and cleaning the brush
Cleaning the machine
• Remove the drain water hose (red) from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
• Proceed in the same way for draining the fresh water tank.
For that purpose, remove the cleaning solution drain hose
(glue) from the holder.
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the dirt sieve (yellow), emp
-
ty it and thoroughly rinse it under run
-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
Attention:
Clogged suction filters may impair the suc
-
tion performance.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
1
1
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
The filter is lower than the drain hole of the
tank. A rest amount of cleaning solution
will run out only when the filter is removed.
• Put the filter back and twist it closed.
Notice:
Clean the brush whenever cleaning work
is completed.
• The machine must be switched off.
• Push the tool ejector briefly but firmly
with your foot.
• Remove the brushes and clean them under running water.
Attention:
Never clean the machine with a high-pres
-
sure cleaner or water jet.
Water ingress in the machine may cause
considerable damage to the mechanical or
electrical parts.
• Wipe the machine with a moist cloth.
