74
TASCAM Portacapture X8
15 - Various settings
15 - 11 Power saving (energy conservation)
mode
This can be set using the GENERAL SETTINGS screen > POWER/DISPLAY page
> POWER SAVE MODE item.
POWER SAVE MODE
When this is on, the settings will become as follows, reducing power
consumption.
BACKLIGHT: 30 sec
BRIGHTNESS: MID
INDICATORS: PEAK LED OFF
CONTRAST: 10
PHANTOM: All off (A pop-up message will not be shown.)
SAMPLE: O nly 44.1/48kHz sampling frequencies can be selected (A
pop-up message will not be shown.)
BACKLIGHT
This sets the display backlight.
OFF: Backlight always off
5–30 sec: Backlight turns off automatically after set time without
operation
ALWAYS: Backlight always on
BRIGHTNESS
This sets the display brightness.
INDICATORS
This sets how the REC and PEAK indicators light.
ALL ON: Both REC LED and PEAK LED light.
PEAK LED OFF: The PEAK LED will not light.
ALL OFF: Both REC and PEAK LEDs will not light.
NOTE
o
If an external power supply that provides current less than 1.5 A is
connected, POWER SAVE MODE will be activated automatically.
POWER SAVE MODE will not be turned off automatically. When
switching to a power supply with 1.5 A current or higher, turn the
POWER SAVE MODE off as necessary.
o
When the POWER SAVE MODE setting is off, BACKLIGHT, BRIGHTNESS
and INDICATORS settings can be made.
15 - 12 Adjusting the display contrast (CON-
TRAST)
This can be set using the GENERAL SETTINGS screen > POWER/DISPLAY page >
CONTRAST item.
Slide the slider left and right to set the contrast between 0 and 20.