26
TASCAM DP-03SD
4 – Preparations
Preparing the power and the SD card
Installing an SD card
1 Open the SD card slot cover on the left side panel of the unit.
2 Insert the SD Card into the slot as shown in the illustration
until it clicks into place.
3 After inserting the card, close the cover.
NOTE
An SD card is installed in the card slot when the unit is
shipped from the factory. You can use this card as is to
record and play back files. There is no need to reinsert it.
Ejecting the card
Push and insert the card further in to eject it.
CAUTION
• Always turn the power OFF before removing an SD card.
Removing a card while the power is still ON will cause any
recordings and settings made since the last time the power
was turned OFF or the song was saved to be lost. These data
and settings cannot be recovered.
• This unit uses SD cards for recording and playback. SD and
SDHC cards that are at least 512 MB in size can be used.
• A list of SD cards that have been tested with this unit can be
found on the TEAC Global Site (http://teac-global.com/).
ª
Write-protected cards
SD cards have write-protect (lock) switches.
Unprotected Protected
When the protect switch is in the LOCK position, files cannot be
recorded or edited on the card. Slide the switch away from the
LOCK position if you want to record, erase or otherwise change
files on a card.
Preparing the power
As shown in the illustration, connect the included PS-1225L AC
adaptor to the DC IN 12V jack.
AC outlet
TASCAM
PS-1225L
DC plug
The bottom panel has a hook (cord holder) that can be used to
hold the AC adaptor cord in place.
When using it, wrap the cord around this cord holder to prevent
it from being disconnected during use.
CAUTION
• Use only the TASCAM PS-1225L AC adaptor and power
cord. Using an AC adaptor other than this one could cause
malfunction, fire or electric shock.
• The AC adaptor must be used to supply power to this unit.
Power cannot be supplied to this unit by USB.
