Tascam Dante ML-4D/OUT-E, Руководство пользователя

Страница: 11 / 80

TASCAM ML-4D/OUT-E / ML-4D/OUT-X
11
Routing setting
Audio can be routed to multiple output channels through
the matrix mixer, the ducking function and the ANC func-
tion.
Output channels
Output equalizer
This unit has 10-band equalizers for the output channels.
Use the equalizer to increase or decrease the levels of spe-
cific frequency ranges. This can be used, for example, to
enhance the sound of individual instruments, to adjust the
balance of a wide frequency range and to cut specific un-
wanted frequencies.
Delay function
Use to adjust the delay of output channel signals.
Output channel fader
Use to adjust the level sent to the output jack.
Output mute
Mute the output channel signal.
Output limiter function
This prevents distortion caused by sudden excessive output
signal levels.
Output polarity setting
Set according to the polarity of the output channel signal.
Application overview
Using the TASCAM DCP CONNECT remote control applica-
tion, you can operate the unit from a distance.
For details about the application, please see its Owner’s
Manual.
You can download the application Owner’s Manual from
the TEAC Global Site (
http://teac-global.com/
).
OUTPUT screen
Notes about Dante
Dante is a transmission protocol developed by Audinate.
Using networks based on gigabit Ethernet standards, it en-
ables multichannel (512 IN/512 OUT) transmission and high
precision, for example.
Check the Audinate website for details about Dante.
https://www.audinate.com/
Connecting to a Dante network
In order to set up and use this card, you must also set up the
Ethernet network that it is connected to, a computer that
runs Dante Controller and other devices that support Dante.
Requirements for LAN cables used for con-
nections with the connectors on this unit
Use STP cables that are at least category 5e.
Both crossover and straight cables can be used.
ATTENTION
This unit is not compatible with 100Mbps Ethernet
switching hubs. Always use switching hubs that support
Layer 2 and Gigabit Ethernet.
NOTE
i
Set the computer to set the IP address automatically.
i
Restarting the computer might be necessary if a previ-
ous network setting is still active on the computer.
Switched (daisy chain) connection
Dante devices can be daisy-chained when there are few
connected devices and when not using a switching hub.
Connect them as shown below.
Switched (daisy chain) connection example
Mixer ML-4D/OUT ML-4D/OUT
NOTE
i
When using a switched (daisy chain) connection, either
DATA or DATA+PoE connectors can be used.
i
If the number of connected devices increases, raising the
latency setting will be necessary.