54
ECO II FEEDING rev.06
ECO II FEEDING
• Entered / Mortality / Delivered:
These are today’s number of entered animals, mortalities and delivered animals.
These menus are shown for consultation only. They cannot be modified.
•
Total Entered / Total Mortality / Total Delivered:
Displays the total number of animal entries, mortalities and the number of
animals that have been delivered from the selected drop’s feed court, since the
beginning of the batch. This value cannot be modified.
• Remaining Count:
Number of animals remaining in drop’s feed court. This value cannot be modi-
fied, it is calculated as follows:
Total Entered - Total Mortality - Total Delivered.
23
ECO II FEEDING rev.06
ECO II FEEDING
2.5.3 Feed Distribution Settings
Refer to section 2.4.1 and 2.4.3 for further information about the feed distribution
process & settings.
Adjust the time and date ............................................... section 5.1
Start the new batch then select the #
of entered animals separately for each drop ..................... section 8.1
Set the clock outputs’ start/stop times (if applicable) ....... section 7.0
Select the feed distribution method (Continuous/Cycled).. section 5.3
Blends’ Ingredients Selection
- without curve ..................................................... section 6.1.1
- with curve .......................................................... section 6.1.2
Dosage selection (if the “Continuous Feeding” option is disabled)
- without blend curve ............................................ section 6.3
- with blend curve ................................................. section 6.1.2
Feed destination (drops) ................................................ section 6.3
Feeding schedule (if the “Continuous Feeding” option is disabled)
without blend curve:
Set the cycles’ start times ...................................... section 6.2
Select each drop’s feed cycle(s).............................. section 6.3
Activate the feed cycles ........................................ section 6.2
or
with blend curve:
Feed cycles in curve is: Enabled in section 5.3
Select each curve point’s feed cycle(s) ................ section 6.1.2.2
or
Feed cycles in curve is: Disabled in section 5.3
Select each drop’s feed cycle ............................. section 6.3
Set the cycles’ start times ...................................... section 6.2
Activate the feed cycles ........................................ section 6.2
Scale Calibration (Last Step) ......................................... section 5.5
On initial startup, perform the scale calibration at
the very end of the programming process. The
controller will start running right after this
calibration is made.
