Tarana Wireless, Inc. ©2021. All rights reserved.
RN Installation Guide vIG_RN_CBRS_2021-08
—
2
Safety and Warnings
Tarana G1 equipment is designed for installation and use by trained
professionals and requires adherence to all relevant regulatory, safety, and
telecom industry best practice guidelines for outdoor radios.
General Warnings
Failure to observe these safety precautions may result in personal injury or
damage to equipment.
•
Follow all warnings and instructions marked on this product.
•
Use standard safety guidelines when mounting. Installation and
maintenance procedures must be followed and performed by trained
personnel only.
•
Before unmounting the product, disconnect power input to reduce the
risk of hazards.
•
Only use Tarana-approved Power over Ethernet (PoE) injectors.
•
Do not open the device. Opening the device voids the warranty.
•
Do not stack anything on the radome.
•
Cable ends must be protected from weather if not connected to the
device.
FCC Information
The FCC occupational controlled limit for maximum permissible exposure
(MPE) is 5 mW/cm
2
. It is estimated that the maximum power density at the
radome is 1.25 mW/cm
2
, which is below the FCC MPE limit. Since the power
density for an occupational controlled environment is less than the FCC limit,
no additional precautions are necessary. The occupational uncontrolled
environment limit for maximum permissible exposure (MPE) is 1 mW/cm
2
. To
meet this MPE requirement, the operator must be at a distance of 63 cm (24.8
in.) away from the radome cover of the system.
General Health and Safety Information
Topic
Explanation
Flammability
The equipment is designed and constructed to
minimize the risk of smoke and fumes during
a fire.
Hazardous Materials
No hazardous materials are used in the
construction of this equipment.
Hazardous Voltage
The G1 system meets global product safety
requirements for safety extra-low voltage
(SELV) rated equipment.
Safety Signs
External warning signs or other indicators on
the equipment are not required.
Surface Temperatures
The external equipment surfaces become
warm during operation, due to heat
dissipation. However, the temperatures
reached are not considered hazardous.
