1. INSTALLATION
IOM manual - Sanitary series
10
1.6.1.
Connection of suction pipe
Remember that the suction pipe/connection is the most critical point, especially if the pump
is priming. Just a small leakage will dramatically reduce the suction capability of the pump.
When connecting the suction pipe, following is recommended.
1)
For satisfactory operation, use reinforced hose (the suction power may otherwise
shrink the hose) or other flexible piping. The internal diameter of the hose should be
the same as on the suction connection (at the bottom of the pump) to have best
suction capability.
2)
Make sure that the connection hose - pump is completely tight, otherwise the suction
capability will be reduced.
3)
Always use as short suction pipe as possible. Avoid air pockets which can arise with
long piping.
1.6.2.
Connection of discharge pipe
For this connection it is only recommended a simple and positive flow connection. Use a hose
or flexible piping (minimum one meter) between the discharge connection and any rigid fixed
piping. Coil the hose at least one turn. All components (hose, pipe, valves etc.) on the discharge
piping must be designed for minimum PN 10.
1.7.
Health and safety
The pump must be installed according to local and national safety rules.
The pumps are constructed for particular applications. Do not use the pump on
applications different from that for which it was sold without consulting us to ascertain
its suitability.
1.7.1.
Protection
In the interest of health and safety it is essential to wear protective clothing and safety goggles
when operating, and/or working in the vicinity of Tapflo pumps.
