TapFlo PT CIP, Руководство пользователя

Страница: 25 / 56

3. MAINTENANCE
IOM manual Tapflo Hose pumps
24
3.7. Lubricant emptying and filling procedure
The quality of the lubricant inside the pump is deteriorating with time. It has to be replaced after
every two hose changeovers or 5000 hours of operating time, whichever comes first. What is more,
the lubricant has to be replaced every time it becomes contaminated e.g. if a hose rupture occurs.
NOTE! Proceed with this procedure only after familiarizing oneself with the instructions at the
beginning of chapter 3. Maintenance and all safety instruction in chapter 1.8. Health and safety .
Fig. 3.7.1
Place a drip pan under the drain plug.
NOTE! Make sure the drip pan is large enough to
contain the whole amount of lubricant that is inside
the pump (see chapter 5.2.
Technical data for more
information).
Fig. 3.7.2
Unscrew the plug [33] and empty the pump form the
lubricant.
NOTE! If the pump is oriented with the manifolds
facing upwards, the drainage is commenced by
unscrewing of a few casing screws [141] on the
bottom of the casing [11].
Fig. 3.7.3
Screw the drain plug [33] back into the pump casing
[11]. Use PTFE tape to seal the connection.
Fig. 3.7.4a
In order to fill the pump with lubricant, remove the
sight glass [41] and its gasket [42] by unscrewing the
sight glass mounting screws [411] and washers [412].
33