©Tansun Limited 2012 Part No. 043083 Issue. 1a
Fig. E
Fig. F
Fig. D
R e p l a c i n g t h e E m i t t e r
1.
Disconnect the power supply by removing the plug from the
mains socket, ensure that the emitter is not illuminated and that
the heater body and emitter are cool.
2.
Remove the three screws and end-cap at one end of the heater
as shown in Fig. D. This will provide access to the safety guard
but will also allow the heater to be slid off the back plate if
you’d prefer to work on a work surface. If you prefer to leave
the heater mounted, take care when handling as it could be
slide off the back plate accidentally.
3.
Remove the safety guard by holding the heater body and
sliding the guard out as shown in Fig. E.
4.
Remove the emitter(s) from the spring loaded holders by
pushing one end further into its holder and by pulling the end
that is free towards you, as shown in Fig. F.
5.
Refit in reverse order.
6. For replacement emitters please contact Tansun Limited.
F o l l o w i n g i n f o r m a t i o n i s o n l y f o r E U - m e m b e r s t a t e s :
The use of this symbol indicates that this product may not be treated as household waste. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the environment and human health
which could otherwise be caused by inappropriate waste handling of this product. For more detailed information
about recycling of this product, please contact your local council, your household waste disposal service or the shop
where you purchased the product.
1
2
M a i n t e n a n c e
In the event of heater failure please contact the retailer or seller in the first instance. For spare parts or advice, please contact Tansun
Limited.
Disconnect from the power supply by removing the plug from the mains socket before commencing any maintenance procedure
including cleaning.
To ensure optimum heat effectiveness, it is recommended that the reflector is kept clean. If dirt appears to build up on the
reflector(s), the safety guard should be removed and the reflector(s) wiped with a lint-free cloth before re-closing.
The heater is supplied with a safety guard. In the unlikely event that this gets damaged, please contact Tansun Limited for an
immediate replacement.
Fig. G
Caution: Do not handle the emitter with bare hands.
Remove finger marks with a lint-free cloth and
methylated spirits or rubbing alcohol. Otherwise, the
finger marks will burn into the quartz glass of the
emitter causing premature heater failure.
Reference Manual
Carnival
Mk. 4 R7s
MODELS FOR UK & EUROPE:
CARN4 1X750H - SINGLE EMITTER MODELS
CARN4 2X750H - DOUBLE EMITTER MODELS
Spectrum House, Unit 1, Ridgacre Road, West Bromwich,
West Midlands, B71 1BW, England.
Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222
Email: [email protected] - Website: www.tansun.com
