![background image](http://html2.mh-extra.com/html/tandelta/oqsexisg2/oqsexisg2_user-manual_4992710062.webp)
Page | 60
9.2
Gateway Configuration
9.2.1
Set up Configuration USB
Before you can use the OQTg it should be configured to work on the particular network which
you have chosen to use. This is done by writing the configuration settings to a USB stick and
uploading to the device. This section assumes you have sensors already configured and installed
for use with the OQTg. If you have not yet configured or installed your sensors, please refer to
Section 5.1.1.5.
9.2.1.1
Run software
Note: Complete the steps below prior to mounting device
1.
Connect OQTg, Gateway Hub OQSxG2 sensors as per diagram below, for detailed wiring
diagram, please see Installation section 9.3.
2.
Remove translucent clip-on cover at front of gateway.
3.
Insert Tan Delta USB stick into a laptop or PC and navigate to OQGatewayConfigurator.exe
(Application File) as shown below. Double click on file to launch program.
OQTh
OQTg
OQSx
3
1
2
4
ID
Description
1
OQSxG2 Sensor to OQTh Gateway Hub Cable
2
OQTh Gateway Hub to OQTg Gateway Cable
3
OQSxG2 Sensor to OQTh Gateway Hub Cable
4
OQTh Gateway Hub Continuity Plug (1 required per
unpopulated sensor slot)
Figure 43
–
OQTg System Architecture
Figure 44 - OQTg Configurator
Содержание OQSExISG2
