EN5990 Encoder for MPEG-4 Part 10
10
NOTE
Refer to the
Reference Guide
for all power supply, fuse, safety, EMC
information and operating conditions.
2.6
Connecting the Encoder to the Power Supply
WARNINGS
1.
Do not overload wall outlets and extension cords as this can
result in a risk of fire or electric shock.
2.
As no mains switch is fitted to this unit, ensure the local
power supply is switched OFF before connecting the supply
cord.
3.
The Encoder is not fitted with an on/off switch. Ensure that
the socket-outlet is installed near the equipment so that it is
easily accessible. Failure to isolate the equipment properly
may cause a safety hazard.
Connect the Encoder to the power supply as follows:
!
Power Supply
Ensure the power supply is isolated and switched off.
!
Encoder
Ensure the correct fuse type and rating has been fitted to both the equipment
and the power cable.
!
Supply Cord
Connect the lead to the Encoder input connector and then to the power
supply. Switch on the power supply.
Table 2.2: Fuse Type and Rating
Power Supply
Fuse Type and Rating
100-120 Vac / 220-240 Vac
Bussmann S505/Littelfuse 215, 5 A 250 V T HBC
-48 Vdc
Bussmann S505/Littelfuse 215, 6.3 A 250 V T HBC
