evolution 5000 E5780 and E5782 Encoder
12
NOTE
Refer to the Reference Guide for all power supply, fuse, safety, EMC
information and operating conditions.
2.6
Connecting the Encoder to the Power Supply
WARNINGS
1. Do not overload wall outlets and extension cords as this can
result in a risk of fire or electric shock
2. As no mains switch is fitted to this unit, ensure the local power
supply is switched OFF before connecting the supply cord.
3. The Encoder is not fitted with an on/off switch. Ensure that the
socket-outlet is installed near the equipment so that it is easily
accessible. Failure to isolate the equipment properly may cause
a safety hazard.
Connect the Encoder to the power supply as follows:
!
Power Supply
Ensure the power supply is isolated and switched off.
!
Encoder
Ensure the correct fuse type and rating has been fitted to both the
equipment and the power cable.
!
Supply Cord
Connect the lead to the Encoder input connector and then to the
power supply. Switch on the power supply.
Table 2.2: Fuse Type and Rating
Power Supply
Fuse Type and Rating
100-120 Vac / 220-240 Vac
IEC/EN 60127-2 Sheet 5
Bussmann S505/Littelfuse 215
5 A 250 V T HBC
