D14128.02—NOVEMBER 2008
41
Codec C90
System Integrator Guide
Contents
Introduction
Getting Started
Interfaces
About the API
xConfiguration
xCommand
xStatus
Cameras
Appendices
Contact us
About the API
Example with xConfiguration Help:
To get help on xConfiguration, type
?
or
help
after the configuration path (address expression):
xConfiguration <address expression> ?
xConfiguration H323 Profile 1 Gatekeeper Discovery ?
*h xConfiguration H323 Profile 1 Gatekeeper Discovery: <Manual/Auto>
OK
xConfiguration operations
Configuration type commands defines system
settings and are either supplied or read by the user.
Return result parameters
Three operations can be performed on
xConfiguration:
Configuration Help
Help text for this configuration is returned
•
Configuration Read
*c
•
is used when returning the result of a
read
query
Configuration Write
No return result parameter for configuration set
•
(write)
xConfiguration Help
To get help on a system setting you can use a help
query. Enter the path followed by
?
or
help
.
xConfiguration H323 Profile 1
•
Gatekeeper ?
Returns information about the setting defined
by the path.
xConfiguration H323 Profile 1
•
Gatekeeper help
As above.
xConfiguration Read
When reading a value you will use the configuration
read. The level of details is defined by the path:
xConfiguration H323 Profile 1
•
Gatekeeper Discovery
Returns the current value of the setting defined
by the path.
xConfiguration Write
When defining a system setting you will use the
configuration write. The structure is described by
the example to the right.
xConfiguration H323 Profile 1
•
Gatekeeper Discovery: Auto
Writes this value to the setting defined by the
path.
Example with xConfiguration Read:
To read configurations from the system just type the root command (xConfiguration) followed by the path
(address expression):
xConfiguration <address expression>
xConfiguration H323 Profile 1 Gatekeeper Discovery
*c xConfiguration H323 Profile 1 Gatekeeper Discovery: Manual
OK
Example with xConfiguration Write:
To issue a command type a root command (xConfiguration) followed by a valid path (address expression).
The path must be terminated with a colon before the value is added:
xConfiguration <address expression>: <value>
xConfiguration H323 Profile 1 Gatekeeper Discovery: Auto
